(makes 1 large round loaf)
An enameled cast-iron Dutch oven with a tight-fitting lid yields best results, but the recipe also works in a regular cast-iron Dutch oven or heavy stockpot.
- 3 cups (15 ounces) unbleached all-purpose flour, plus additional for dusting work surface
- ¼ teaspoon instant yeast
- 1 ½ teaspoons table salt
- ¾ cup plus 2 tablespoons water (7 ounces), at room temperature
- ¼ cup plus 2 tablespoons (3 ounces) mild-flavored lager (such as Budweiser)
- 1 tablespoon white vinegar
- Non-stick cooking spray
- Whisk flour, yeast and salt in large bowl. Add water, beer and vinegar. Using rubber spatula, fold mixture, scraping up dry flour from bottom of bowl until shaggy ball forms. Cover bowl with plastic wrap and let sit at room temperature for 8 to 18 hours.
- Lay a 12- by 18-inch sheet of parchment paper inside a 10-inch skillet and spray with nonstick cooking spray. Transfer dough to lightly floured work surface and knead 10 to 15 times. Shape dough into ball by pulling edges into middle. Transfer dough, seam-side down, to parchment-lined skillet and spray surface of dough with nonstick cooking spray. Cover loosely with plastic wrap and let rise at room temperature until dough has doubled in size and does not readily spring back when poked with finger, about 2 hours.
- About 30 minutes before baking, adjust oven rack to lowest position, place a 6- to 8-quart heavy-bottomed Dutch oven (with lid) on rack, and heat oven to 500 degrees. Lightly flour top of dough and, using razor blade or sharp knife, make one 6-inch long, ½-inch-deep slit along top of dough. Carefully remove pot from oven and remove lid. Pick up dough by lifting parchment overhang and lower into pot (let any excess parchment hang over pot edge). Cover pot and place in oven. Reduce oven temperature to 425 degrees and bake covered for 30 minutes. Remove lid and continue to bake until loaf is deep brown and an instant-read thermometer inserted into center registers 210 degrees -- 20 to 30 minutes longer. Carefully remove bread from pot; transfer to wire rack and cool at room temperature, about 2 hours, before slicing.